Mr.Basic Painting Booth Wide FT05: Setup and Spray Safety

By Argama Hobby - Gundam Model Kits & a Pro Build Space for ... | Published: 2026-10-31

Category: Tips & Care

Set up the Mr.Basic Painting Booth Wide FT05 for safer indoor airbrushing. Follow these steps for ventilation, filter placement, and spray technique.

Quick answer

Assemble the FT05 booth with its honeycomb filter, position it near a window or vent, and use a fan or open window to exhaust overspray. Always wear a respirator and test airflow before painting to keep indoor air safe.

Why the FT05's wide filter matters for large parts

The FT05 uses a wide honeycomb filter, similar in size to the GT03 booth, which helps capture paint mist from long spray strokes typical of large model parts. This reduces paint backflow and keeps more overspray inside the booth instead of your room.

When a spray booth alone isn't enough

A spray booth captures overspray, but it doesn't replace ventilation or a respirator. If you're spraying solvent-based paints or working in a small room, you still need open windows, a fan, and proper respiratory protection. The FT05 is a tool to reduce mess, not a substitute for fresh air.

Step-by-step FT05 setup and spray safety

Assemble the booth and attach the filter: Unfold the cardboard booth and secure it with the white adhesive tape. Place the honeycomb filter in the designated slot, ensuring it sits flat and covers the opening. Common mistake: forgetting to tape all edges, which lets paint leak out. Check that the filter is fully seated before each session.
Position the booth for airflow: Place the booth near an open window or a vent, ideally with a fan blowing air out of the room. Keep the booth on a stable surface at a comfortable working height. Common mistake: placing it in a closed corner where overspray can linger. Never spray in a room without cross-ventilation.
Set up your spray area: Lay down newspaper or a drop cloth around the booth to catch stray drips. Keep paints and thinners capped when not in use. Common mistake: overcrowding the booth with parts, which blocks airflow and reduces filter effectiveness. Leave space around the booth for air to circulate.
Test airflow before painting: Turn on your fan or open the window fully, then spray a test burst of water or air through the airbrush to check that mist is drawn toward the filter. Common mistake: skipping the test and discovering poor airflow after you've started painting a model. If mist hangs in the air, improve ventilation before continuing.
Wear a respirator and spray in short passes: Put on a properly fitted respirator before spraying. Hold the airbrush at a consistent distance and use smooth, overlapping passes. Common mistake: spraying too close or too slowly, which floods the filter and causes paint buildup. Replace the filter when it becomes visibly clogged or paint transfer worsens.

Product facts

Mr.Basic Painting Booth [Wide] (FT05): Wide honeycomb filter designed to catch paint mist and reduce backflow. This means fewer paint particles escape into your room, so you can spray larger parts with less mess.
Mr.Basic Painting Booth [Wide] (FT05)