MG 1/100 G-Fighter: Pairing It With Your Master Grade Gundam

Quick answer

Build the MG 1/100 G-Fighter as a standalone support craft first, then display it alongside your Master Grade Gundam using a shared action base or a dedicated shelf. Focus on clean snap-fit assembly and panel lining to match your Gundam's finish.

Step-by-step build and pairing process

1. Prepare your workspace and tools: Clear a flat, well-lit area and gather nippers, a hobby knife, and sanding sticks. Common mistake: using dull nippers, which can stress the plastic and leave white marks. Checkpoint: ensure your nippers cut cleanly through a test sprue before starting. A clean cut now saves cleanup later.
2. Assemble the G-Fighter in sub-sections: Follow the manual to build G-Part A and G-Part B separately, but don't snap them together yet. Common mistake: attaching the two parts too early, which makes it harder to handle each section during cleanup. Checkpoint: test-fit each part before final snapping. Keep the parts separate until cleanup is complete.
3. Clean up nub marks and seam lines: Use a hobby knife to shave down remaining nubs, then sand progressively from coarse to fine grit. Common mistake: skipping sanding, which leaves visible marks that show under topcoat. Checkpoint: run your finger over the surface—it should feel smooth. Smooth surfaces make panel lines pop.
4. Apply panel lines for mechanical detail: Use a fine-tip panel line marker or wash to highlight the G-Fighter's engraved details, especially around the container compartment and generator. Common mistake: applying too much pressure and pooling ink. Checkpoint: wipe excess immediately with a cotton swab. Less is more—build up lines gradually.
5. Choose your display configuration: Decide whether to show the G-Fighter as a complete craft, as separate G-Part A and G-Part B, or docked with your Gundam. Common mistake: forcing parts together without checking alignment. Checkpoint: ensure all connections are secure but not stressed. Test different poses before finalizing.
6. Position alongside your Master Grade Gundam: Use an action base or display stand to pose the G-Fighter flying near your Gundam, or place it on a shelf at a similar height. Common mistake: overcrowding the shelf, which hides details. Checkpoint: leave enough space for both kits to be visible from multiple angles. Give each kit room to breathe.

Product facts

• Master Grade (MG) 1/100 G-Fighter: The MG 1/100 G-Fighter is a snap-fit plastic kit that separates into two main components: G-Part A and G-Part B. This means you can display it as a single craft or as separate parts, giving you flexible display options alongside your Gundam.